When the laser cutting air compressor is working, it is very dangerous if it breaks down. Novices must be trained by professionals before they can operate independently. Based on experience, 13 details of the safe work of the laser cutting air compressor are summarized:
1. Observe the general safety operation regulations of cutting machine. Start the laser in strict accordance with the laser startup procedure.
2. Operators must be trained, familiar with equipment structure and performance, and master relevant knowledge of operating system.
3. Wear labor protection articles as required, and wear protective glasses that meet the requirements near the laser beam.
4. Do not process a material until you know whether it can be irradiated or heated by a laser, so as to avoid the potential danger of smoke and steam.
5. When the equipment is started, the operator shall not leave the post without authorization or entrust someone to take care of it. If it is really necessary to leave, the operator shall shut down or cut off the power switch.
6. Keep the fire extinguisher within easy reach; Turn off the laser or shutter when not processing; Do not place paper, cloth or other inflammables near unprotected laser beams.
7. In case of any abnormality during processing, the machine shall be shut down immediately to eliminate the fault or report to the supervisor.
8. Keep the laser, the bed and the surrounding area clean, orderly and free of oil stains. The workpieces, plates and wastes shall be stacked as required.
9. When using gas cylinders, avoid crushing welding wires to avoid electric leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder supervision regulations. Do not expose the cylinder to the sun or close to the heat source. When opening the bottle valve, the operator must stand at the side of the bottle mouth.
10. Observe high voltage safety regulations during maintenance. Every 40 hours of operation or weekly maintenance, every 1000 hours of operation or every six months of maintenance shall be carried out in accordance with the regulations and procedures.
11. After starting the machine, manually start the machine tool in the X and Y directions at low speed to check whether there is any abnormality.
12. After inputting the new workpiece program, the test run shall be carried out first, and the operation of the laser cutting air compressor shall be checked.