An air compressor is a device used to compress gas. It is a device that converts the mechanical energy of the prime mover (usually an electric motor) into gas pressure energy, and is a pressure generating device for compressed air. The laser cutting air compressor is an integral part of the fiber laser cutting machine system. The following is the maintenance and maintenance work of its main components.
1. Air filter element. Under normal circumstances, the dust and impurities on the surface of the air filter element should be removed every 500 hours, and it should be checked every 2000 hours whether it needs to be replaced. The inspection or replacement cycle can be determined by referring to the instruction manual according to the dust content.
2. Intake valve seals. Every 4000 hours of operation of the air compressor of the laser cutting machine, check the condition of the sealing ring and replace it if necessary.
3. Compressor lubricating oil. Check the lubricating oil every 1000 hours and replace the lubricating oil every 4000 hours.
4. Oil filter. Parts should be replaced every 2000 hours.
5. Oil vapor separator. Parts need to be replaced every 4000 hours.
6. Pressure valve. Clean it every 4000 hours and check whether the opening pressure is normal.
7. Safety valve. Check its agility every 4000 hours.
8. Drain valve. Moisture and dirt are drained every 2000 hours.
9. Transmission belt. Adjust the tightness every 2000 hours, check the wear every 4000 hours, and decide whether to replace it according to the wear.
10. Motor maintenance. Carry out maintenance according to the motor instruction manual.
In order to make the air compressor of the laser cutting air compressor run normally, remind you to formulate a detailed maintenance plan, perform scheduled operations, regular maintenance, and regular inspection and maintenance to keep the air compressor unit clean, oil-free, and dirt-free .