How to determine the factory Rotorcomp air compressor gas supply plan, according to the factory scale, gas point distribution, gas supply pressure level and required compressed air quality, after comprehensive consideration and technical and economic conditions. There are generally 6 gas supply plans:
1. Set up regional compressed air station gas supply. When the factory is large in scale, the compressed air consumption is large and the main users are relatively dispersed, in order to reduce the pressure loss of the pipeline network and ensure the use of key gas, this plan is often used. There should be pipelines connecting the regional station buildings to achieve the purpose of mutual load adjustment and mutual backup.
2. Set up several compressed air stations for gas supply. This plan is mainly used for small and medium-sized factories and large factories with relatively concentrated gas consumption.
3. On-site gas supply plan. When the factory gas consumption is not large, the gas consumption points are few and dispersed, it can be considered to use a small air compressor unit near the starting point.
4. A gas supply plan combining centralized and decentralized. In some large and medium-sized factories, the main compressed air consumption is more concentrated, and the secondary is more dispersed. Especially at night, the gas consumption is less, so this solution is suitable.
5. When the factory needs to supply different compressed air, and the low-pressure gas consumption is large, it should consider using gas supply systems with different pressure levels and configuring air compressors with different pressures. To reduce the energy waste caused by pressure reduction, but the gas supply pressure level should generally not exceed two, so as to reduce the initial equipment investment.
6. When some gas points in the factory need to supply higher quality compressed air, it can be considered to use a single oil-free lubricated ten air compressor. It can also be considered to use the compressed air supplied centrally, and then process some post-processing equipment for gas supply. The specific method to be adopted should be determined after comprehensive economic comparison, depending on the specific gas consumption and the location of the gas point.
In summary, the determination of the gas supply plan is an issue that needs to be considered comprehensively, involving the user's initial investment, the management of the production process, and especially for users who expand production and increase the amount of compressed air, it should be combined with the layout of the original compressed air supply system. There is one thing that Fusheng Air Compressor would like to remind its users: if an oil-injected screw air compressor is used, it does not require a special air compressor foundation and station building, nor does it require a full-time operator to monitor it like a piston air compressor. Therefore, Fusheng Air Compressor recommends that you should try to avoid using centralized air supply and the customary air supply solution of transporting air over long distances, so as to achieve the goal of saving energy and investment while ensuring air supply requirements.